Skip to main content
4.1.11 - Released November 24, 2025
- Switches:
- BUGFIX: PSX8/PSX10:PSX28: traffic prioritization on SFP port can lead to packet loss
- BUGFIX: PSX8/PSX10/PSX28: LLDP neighbor discovery on STP blocked port
- BUGFIX: PSX8/PSX10:PSX28: as-needed dynamic PoE budget allocation
- BUGFIX: PSX8/PSX10/PSX28: occasional packet loss to CPU port
4.1.10 - Released October 22, 2025
- Access Points:
- BUGFIX: probe for DHCP server after initial DHCP probe timeout
- Switches:
- BUGIFX: PS8-L/PS24-L/PS24/PS48: race condition preventing cloud communication
4.1.9 - Released October 20, 2025
- Access Points:
- FEATURE: DHCP filtering replaces secondary Ethernet port quarantine mode
- FEATURE: UDP traffic logging via remote syslog
- FEATURE: captive portal: log missing parameters on splash page invocation
- BUGFIX: PAX1800-Lite: occasional mangled client fingerprinting
- BUGFIX: PAX1800v1: missing capport setting in DHCP server response
- Switches:
- BUGFIX: PS8-L/PS24-L/PS24/PS48: double counting of MAC addresses across multiple VLANs
- BUGFIX: PS8-L/PS24-L/PS24/PS48: statistic retrieval regression introduced with 4.1.8
- BUGFIX: PSX8/PSX10/PSX28: send / receive LLDP packets on STP blocked ports
- BUGFIX: PSX8/PSX10/PSX28: hardware timers reduce busy cycles & CPU load
- BUGFIX: PSX28: occasional layer 2 forwarding database corruption
4.1.8 - Released August 25, 2025
- Access Points:
- BUGFIX: PAX1800-Lite: race condition during WiFi SSID bring up
- Switches:
- BUGFIX: PSX8/PSX10/PSX28: filter multicast addresses from connected devices table
- BUGFIX: PSX8/PSX10/PSX28: port mirroring settings not applied
- BUGFIX: PSX8/PSX10/PSX28: incomplete port traffic counters
4.1.7 - Released August 12, 2025
- Access Points:
- BUGFIX: wired clients connected to mesh AP
- BUGFIX: WiFi 6 mesh recovery in unencrypted networks
- Switches:
- FEATURE: PSX8/PSX10/PSX28: firmware installation via local device page
- BUGFIX: PSX8/PSX10/PSX28: MSTP stability
4.1.6 - Released June 24, 2025
- Access Points:
- FEATURE: per-SSID configurable RADIUS service-type
- Switches:
- FEATURE: PSX28: monitor & report SFP tx_failure state
4.1.5 - Released June 18, 2025
- Access Points:
- FEATURE: secondary Ethernet port isolation when bridged into SSID with client isolation on
- FEATURE: captive portal: set "Service-Type" to Call-Check to differentiate auth from preauth
- BUGFIX: PAX5400: captive portal user traffic counters
- BUGFIX: PA2200: cloud configuration parse failure
- BUGFIX: PA300/PA300E: WiFi scan incompatibility
- Switches:
- BUGFIX: PSX28: PoE faults retrieval never returns result
- BUGFIX: PSX28: init PoE chip config when necessary
4.1.4 - Released May 21, 2025
- Access Points:
- BUGFIX: PAX5400: performance improvement on non-throttled SSID
- Switches:
- FEATURE: PSX28: indicate missing IP configuration via red LED
- BUGFIX: PSX28: use device MAC for DHCPv4/DHCPv6 requests
- BUGFIX: PSX28: handle DHCPv4 renew event
- BUGFIX: PSX28: delay port traffic forwarding on booot until after all port configs are applied
4.1.3 - Released February 19, 2025
- Access Points:
- FEATURE: IPv6 uplink support via DHCPv6
- FEATURE: IPv6 LAN/Gateway/DNS address reporting
- FEATURE: syslog: TCP log for connections on ports 1023-65535
- FEATURE: SSID routing mode DHCP RFC8910 capport support
- FEATURE: captive portal: Captive Portal API (RFC8908)
- FEATURE: captive portal: session timeout & throughput limit update via RADIUS accounting update
- FEATURE: captive portal: report WiFi band via RADIUS Nas-Port-Id attribute
- FEATURE: captive portal: replace self-signed certificate with captive-portal.info
- BUGFIX: PAX5400: improve 5GHz ambient noise scanning
- Switches:
- FEATURE: PSX28 platform support
Comments
0 comments
Article is closed for comments.